SKATEBOARD AGAIN!

HELLO GUYS!
Do you remember my first post ?
yeah right, my first post is talking about the history about skateboard in Indonesia. But before I tell you about tips and trick skateboards I will tell tou about the skateboard parts and how to set up a skateboard.
few thing you will need:
1.  Deck 
2. Griptape
3. Truckers
4. Bolds
5. Wheels
6. Bearings
7. Tool kits
How to set your own skateboard:
first you need to paste the griptape to the deck. Second you must installing bold to truckers with tool kits. and then place bearing into wheels.,so now wheels can place on the truckers.Finally you can use your skateboard.


And now I will tell you about skateboarding tricks you can learn and practice this trick with your skateboard.
KICKTURN
 Most skaters think that the first basic skateboard trick is the ollie, but it's not! That's a trap! The ollie can actually be difficult to learn for a lot of skaters, and most skaters will learn a lot better if they truly start with the basic skateboard tricks! And one of the MOST basic, is the kickturn.
Kickturning is the name for when you need to turn quickly, and so instead of simply leaning and carving, you lift your front trucks off the ground, and pivot. Learning to kickturn takes balance, and the more you practice your kickturns, the better your balance will become!

OLLIE
is jumping with the board with the front wheels leaving the ground first. This motion is attained with a snap of the tail (from the backfoot) and sliding your front-foot forward to reach any altitude. A lot of technical tricks transpire from this element (eq. the kickflip, heelflip, 360-flip etc..). A Nollie is when the back wheels leave the ground first, or relatively, it's a switch-stance ollie riding fakie.

The rider begins the ollie by crouching and jumping directly upward. As the rider begins to leap, instead of lifting the feet from the board, he/she "pops" the tail by striking it against the ground, which raises board nose-first. Maintaining contact with the board, the rider lifts the front leg and bends the front ankle so that the outer or top side of the shoe slides towards the nose of the board. The friction between the shoe and the board's grip tape helps to guide and pull the board upward, while the rear foot only maintains slight contact with board to help guide it. When nearing the peak of the jump, the rider lifts the rear leg and pushes the front foot forward, which levels the board and keeps it in contact with the back foot.

The skater can gain greater clearance from the ground by jumping higher, popping faster, sliding the front foot farther forwards (starting the jump with the front foot farther back), and pulling the legs higher into the chest to raise the feet higher. Skaters attempting record-setting ollies even contort the legs so that board and feet are not directly below them, allowing the board to rise at or just below the level of the pelvis.
Very low ollies can be achieved using the same technique, but without the tail making contact with the ground. Even basic flip tricks can be achieved without the "pop" of the tail.

50-50 GRINDS
The 50-50 grind is the first grind trick that most skaters learn, and is a great basic skateboard trick to learn. The 50-50 grind is where the skater grinds the ledge or rail with both trucks. The nice thing about the 50-50 is that you can learn to do it on a curb, which is a pretty safe and easy place to practice. 

SLIDES
developed many tricks of slide tricks this is m the evolve of the slides tricks

Anti-Casper Slide

Performed by flipping the board into a nosecasper via half impossible and sliding on the nose in a nose casper position.

Bert Slide

A four wheeled slide in which the rider puts one hand on the ground and rotates the board while it's still "grounded". Used to brake, turn, or just show off. Originated in 'DogTown' while Tony Alva etc. attempted to copy surfers

Bluntslide

Performed by ollieing over/onto the obstacle and fitting the edge/rail between the tail and back truck of one's skateboard and sliding. Can be performed on flat ground (called a bluntstop) or downhill, possibly with only the tip of the board sliding on the street and all four wheels lifted.

Boardslide, aka railslide

The board straddles the obstacle perpendicularly as the skateboarder slides along the center of the board.

Casperslide

A casperslide is performed by flipping the board into an up-side down state with one foot on the bottom (now top) of the tail and the front foot underneath the front truck (griptape side) and sustaining momentum, thus sliding on the tip of the board's concave. It can be performed on rails (rarely done) or flat ground. Often Attributed to Rodney Mullen.

Crail Slide

This is a tailslide where the skater grabs the nose of the board with the back hand while sliding. Usually performed on a ramp. It comes from the same idea as the more popular Lien Slide, in that in both tricks the skater grabs the board to help put it in position for the tailslide. Since the invention of the Ollie, it is more common to Ollie in to a tailslide.

Darkslide

The Dark slide is a seemingly complicated looking trick in which the rider approaches a ledge or rail and does a flip trick onto the obstacle so that the rider lands on the board upside down with their feet on the nose and the tail and slides across the obstacle. Generally a half-kickflip or half-heelflip is the flip trick used to get into a darkslide. Created by Rodney Mullen

Lipslide

Similar to a boardslide only the skater turns 90 degrees so that the trailing trucks are placed over the rail/ledge/coping and the skater slides on the middle of the board. Considered more complex than a boardslide due the rotation over the obstacle at the beginning into the trick and the re-entry or dismount. Note that in this case a frontside lipslide involves facing forwards while a backside lipslide involves facing backwards. Also known as a Disaster slide.

Nailslide

A combination of a tailslide and a nose slide between two obstacles at the same time, thus the name.

Noseblunt

Same as a blunt slide, only performed with the nose and the front wheels. 90 degree ollie over the object to be sliding, locking the nose into a slide position. Wheels drag across the ledge/platform like a power slide while the nose slides along the lip. on a rail, the rider 'ollies over' into a nose slide position.

Nose grab tail drag

The skater pops the board into his hand, grabs the nose, and pulls up so that the wheels come off the ground and only the tail is sliding.

Noseslide

A noseslide is performed by riding parallel to an obstacle (ledge, rail, etc...) The skateboarder then does an ollie and turns the board 90 degrees. They then land on the ledge with the nose of the board sliding on top of it. This can be done frontside or backside. The skateboarder can then come off the ledge either regular or fakie (backwards).

Tailslide

Similar to the noseslide only when turning 90 degrees the tail of the board is landed on the edge of the ledge/rail.

Powerslide

The powerslide is a four wheel slide usually performed to stop the skateboard. It is performed by gaining speed, and turning the board 90 degrees while leaning the body back. The hands do not touch the ground when performing a powerslide. The skater can also turn the board more than 90 degrees resulting in the board continuing to roll and a very stylish maneuver. If the rider is going fast enough downhill it is possible to do powerslide rotations. Can also be done leaning forward but must be rotated the opposite way, which makes it similar to a bert slide but without placing the hand on the ground.

Cess Slide

This is a four wheeled slide performed on inclines, banks, ditches, and transition. most common riding frontside or straight up the transition. At the peak of momentum, the rider unweights the board and slides the back wheels up to 'catch up' with the rest of the body at 90 degrees. Then as the body's momentum returns, the rider pivots the back truck while sliding the front wheels 90 degrees back toward the bottom of the incline. Simply put, backside shred up, pivot back down. A fun lazy way of riding transition backside. if you ride up frontside, you do this trick in a backside 'alley-oop' fashion. This is also VERY common in backyard pool riding, due the benefits of 'feeling' your way around the cement.

Coleman Slide

This is where a rider wearing sliding gloves performs a frontside slide using their downhill hand with the glove to break the wheels free of traction while swinging the uphill hand close to the body to revert the board back from the initial slide in a pendulum motion. Named after slalom champion and sliding godfather Cliff Coleman, it is regarded as a staple trick in downhill sliding because it allows riders to see what is coming at them (objects, cars, hazards) all while in control. A Coleman slide can also be used to initiate a frontside spin if the rider ends the slide at 180 degrees instead of swinging back to the original stance with a pendulum. If the rider flows into a backside slide with one smooth motion, it is possible to do 360 spins and more.

Toeslide

This is a backside slide where the rider puts both hands on the street in front of their toes and extends their body out into a push-up position (you can also keep your knees bent in order to spin around faster), either returning to the original stance with a pendulum or rotating a full 180 degrees. A more difficult variation is to put only your uphill hand on the pavement and slide with your shoulders perpendicular to the ground. Toeside 360s can be done by continuing immediately into a frontside slide after the first 180 degrees.

Layback

Also known as a Sergio slide (named after the Brazilian inventor of the move, Sergio Yuppie), a layback is a frontside slide performed while riding downhill by placing your uphill hand on the ground behind the tail of your board and breaking the rear wheels out of traction. From here you can rotate 180 degrees, swing a pendulum, or hold the slide at 90 degrees and thrust your pelvis upward to unweight the board, resulting in a longer slide. The last variation is considered to be the most challenging and stylish, but often results in flatspots on your wheels. Like all hands-down slides, this trick requires slide gloves to be executed at speed.

Surrender Slide

Another downhill slide requiring slide gloves, a surrender slide is when a rider places both hands on the street in front of their board and lowers their upper body close to the pavement, extending their legs behind them and gripping the board with the sides of their feet. While not a particularly difficult or impressive slide, it is useful for linking together various other downhill slides. The wheels do not necessarily slide in a surrender because the deck remains pointing downhill, although it is possible to drift in this position.

Pressure spin

A hands-down rotation in the Surrender position. The slide can either be initiated by diving forward into a surrender slide and slinging the board around with your legs, or by doing a frontside or backside 360 and continuing the spin in a surrender position. Skilled riders can rotate as much as 1440 degrees or even more (there is no official record). Once the technique is perfected it allows you to rotate fast and slide very far while losing very little momentum due to the rider's weight being on his gloves when his board is sliding and on his board when it is pointing downhill and rolling.

Nose/Tail 5-0 Slides

A 5-0 Slide can be done frontside or backside, with either the front two or the rear two wheels sliding on the ground while the rider is sliding standing up or with his hands on the pavement. If the nose or tail of the board slides on the ground it is considered a bluntslide

 

MANUAL

The manual is a great basic skateboard trick to learn - mainly because it's a trick that you can ALWAYS improve on! A manual is something like a "wheelie" on a bike. The skater balances on his or her back wheels, and continues rolling. A nose manual is similar, just off the skateboard's nose. The trick to manualing is balance, confidence, and just doing it. But be careful - it's very easy to lean too far back and launch your board out in front of you!